Starting from Windows ® 10, the STSW-STM32102 driver is no more adequate and the usage of the native inbox driver is recommended. Key Features Virtual COM port driver installation package for Windows ® operating systems: 98SE, 2000, XP, Vista ®, 7, and 8.x. STM32 Virtual COM Drivers 64bit (PC) KISS - Keep It Super Simple - Flyduino FCs & ESCs STM32 Virtual COM Drivers 64bit (PC) Version: Download: 84956; Total Views. After installing the STM virtual COM port driver, Windows Device Manager showed a STMicroelectronics Virtual COM Port, but with a yellow warning mark. The COM port was not accessible with a terminal appliaction (PUTTY). I eventually found that there is a problem with source code output from the STMCube program. But there is a simple fix. After the STM32 is successfully flashed, jump to the Start the Example section. Start the Example. While the toolchain builds the project and launches the debug session, open the Device Manager in Windows OS to see the COM Port Number assigned to the USB device STMicroelectronics STLink Virtual COM Port.

Mac (79) BSD (67) Other Operating Systems (5). Zoom via RS485 Huawei E3372 modem - Send sms via USB virtual serial port STM32 series. Device CAN driver, VCA.

Important changes to forums and questions

All forums and questions are now archived. To start a new conversation or read the latest updates go to forums.mbed.com.

6 years, 8 months ago.

STM32F401RE Nucleo - Virtual COM Port is not working properly

Hello there,

I've been using the Nucleo for some time, and I found out there is a problem with the VIrtual COM port. Free font for alice in wonderland. I used a sample test program from the library (printf) and any of the terminal software I've used does not show any output despite the Virtual COM Port is detected. However, when I used an external USB->UART converter (available cheaply in your local stores), and jumper the converter's RX pin to the CN3's RX pin, I see the output clearly. The funny thing is, is the CN3's RX pin a TX pin? I felt that this has printed wrongly on the board.

Here's the steps I've done:

1.) Installed the Virtual COM Port Drivers (VCP 1.3.1) and reinstalled it.2.) Tested with all different libraries of printf, and it didn't do much - detected but not getting outputs or inputs.

Is the UART module in the ST-Link on the board not working? Or did I miss something here?

Thanks,N.

Question relating to:

I've found that it does work, but only about 1/10 times

Stm32 Virtual Com Port Driver Mac

Stm32 Virtual Com Port Device Driver For Mac Download

Hello,

I tried plugging it in my Win8 laptop, and with the drivers installed, and it worked flawlessly.

Rdf editor for mac. On the other Win7 laptop, it behaves in an erratic manner initally, and then after that behaves exactly like my main computer.

Is it the driver problem for Win7, or is it the Virtual COM Port (and its drivers) not optimized for Nucleo?

Thanks,N.

Stm Virtual Com Port Driver